AC repair
Furnace & heating
Heat pumps
Ductless mini splits
Carrier
Trane
GoodmanSeasonal tune-up and full diagnostic on your Carrier, Trane, or Goodman system - readings shown to you before any repair is proposed
Diagnosis first, numbers second - you approve the repair price before a single part goes in.
Get your free estimateWhy Spring Valley Homeowners Choose Lennox HVAC
Dalton Heating & Air Spring Valley provides independent Lennox HVAC service in Spring Valley, NV, covering AC repair, furnace repair, and furnace tune-ups on Lennox Merit, Elite, and Dave Lennox Signature Collection equipment. What makes our Lennox work different is familiarity with the model lines themselves: we know which failures show up on a 13ACX and which belong to a communicating SL25XPV, so diagnosis starts with the equipment rather than a generic checklist. We’re an independent service provider, not authorized, endorsed, or backed by Lennox, and we’re reachable at (888) 268-6106.
Lennox systems are everywhere in Spring Valley’s stucco tract subdivisions, from builder-grade Merit furnaces in 1990s two-story plans to Elite variable-capacity units swapped in during the 2000s. Because we’re independent, our recommendations come from what your equipment actually needs, not from a manufacturer program that rewards selling a particular line.
Why Trust Dalton Heating & Air Spring Valley for Your Lennox HVAC?
Our technicians have up to 23 years of experience, and a good share of that has been spent in front of Lennox equipment: pulling fault codes from the integrated furnace control, tracing communicating wiring on Signature systems, and testing smart valves on Merit and Elite furnaces that won’t hold ignition. That matters more on Lennox than on some brands, because the diagnostic path runs through the control board rather than a set of simple mechanical checks.
We use OEM-compatible parts on Lennox control boards, iComfort components, and coil assemblies, which is where a mismatch between aftermarket and factory spec tends to cause callback problems. Capacitors, ignitors, and common wear parts get quality aftermarket replacements that meet or exceed spec. Service is warranty-safe: we document what we find and what we replace, and we don’t take shortcuts that give a manufacturer a reason to deny a claim on a system still under coverage. Every repair comes with a written price before work starts and a written guarantee for a full year. If the repair fails in that time, we come back at no charge.
Styles & brands we work with
- AC repair
- Furnace & heating
- Heat pumps
- Ductless mini splits
- Carrier
- Trane
- Goodman
Common Lennox HVAC Problems We Fix in Spring Valley
These are the Lennox failures we see most in Spring Valley, tied to the model lines that produce them.
- Smart valve and IFC control board failures on Merit and Elite furnaces. The ML193 and ML195 furnaces, along with older Elite models, are prone to intermittent ignition. The unit lights, runs a few minutes, drops out, and comes back, and there’s no obvious thermostat fault. The cause is usually a failing smart gas valve or a control board that won’t hold the ignition sequence, not a thermostat problem or a dirty flame sensor alone.
- Leaking indoor coils on older 410A Lennox air handlers and coils. This shows up as low charge and ice on the suction line rather than an obvious refrigerant puddle. On a 2000s-era Lennox air handler, a coil leak presents as a system that cools poorly and freezes the line set, and the real question becomes coil replacement versus a recharge-plus-seal decision based on unit age.
- Failed run and dual capacitors on outdoor units. Desert summers push Lennox condensers near-continuous June through September, and capacitors fail hard. When a run or dual capacitor goes, it often takes the compressor’s start winding with it, which turns a small part into a much larger repair if it isn’t caught quickly.
- Communicating system faults on Dave Lennox Signature Collection equipment. The iComfort thermostat loses contact with the indoor or outdoor unit, and the code points to a wiring or board communication problem. The mechanical components may be fine. The fault is in the communicating path, and a tech who treats it as a mechanical failure will chase the wrong part.
- Upstairs comfort complaints on two-story subdivision homes. Many Spring Valley two-story plans have long second-floor duct runs through attics that hit 140 – 160°F, and an upstairs Lennox system starved by that duct run gets blamed for a cooling failure that’s really a distribution problem. The equipment is running, but the air isn’t arriving.
Lennox Parts & Our Repair-vs-Replace Approach
We lean OEM on Lennox control boards, iComfort components, and coil assemblies, because a spec mismatch there produces callbacks and, on communicating systems, faults that don’t clear. Capacitors, ignitors, and common wear parts get quality aftermarket parts that meet or exceed factory spec. We don’t claim to stock Lennox parts locally. Every part is sourced for the specific job, so we quote lead time honestly and tell you upfront if a Signature board needs to be ordered.
The repair-versus-replace call is where an honest shop earns its keep. On a failed compressor or a leaking coil in a Lennox unit over roughly 12 to 15 years old, replacement is often the right answer, and we’ll say so rather than sell a repair that doesn’t pencil out. On a newer system, the same symptom usually justifies repair. Call (888) 268-6106 and we’ll put the price in writing before any work begins.
Our Lennox Service Process – Step by Step
- 1
Diagnosis. We pull the Lennox fault codes first, then test the components they point to: pressure switch and flame sensor on a furnace ignition problem, suction and liquid pressures on a suspected coil leak, run and dual capacitors with a meter rather than by eye.
- 2
Written price. You get the repair scope and the dollar amount in writing before anything is replaced. Overtime isn’t added for evening or weekend calls.
- 3
Repair or install. Work is done by the book, with OEM or OEM-compatible parts where the system calls for them. For a communicating Signature system, we verify the iComfort settings after the repair, because a board swap can reset configuration.
- 4
Test and document. We run the system through a full cycle, confirm temperatures and pressures, and leave you a written record of what was replaced and why.
- 5
Guarantee. Every repair carries a written guarantee for a full year. If it fails in that time, we return at no charge.
See the difference
Before
After
Before
After
Before
AfterLennox Products We Service & Install in Spring Valley
We service and install across the Lennox lineup you’ll find in Las Vegas Valley subdivisions. That includes the Merit Series (13ACX and ML14XC1 air conditioners, ML193 and ML195 furnaces), the Elite Series (XC13, XC16, and the SL18XC1 variable-capacity unit), and the Dave Lennox Signature Collection (SL25XPV and SL28XCV systems, plus SLP98V furnaces). We also work on Lennox ductless and mini-split systems, including the MS8C and M Series multi-zone units. Whether it’s a builder-grade Merit furnace or a Signature system with an iComfort thermostat, we service it.
We Also Service These Brands
Dalton Heating & Air Spring Valley isn’t a single-brand shop. Our technicians are factory-trained to service nine major residential HVAC brands, including Carrier and Trane, so if your home ends up with a mixed setup, or you’re comparing a Lennox replacement against a Carrier or Trane system, we can service and install all of them and give you a straight comparison.
FAQs – Lennox HVAC Service in Spring Valley
Watchguard means the Lennox control board has counted too many failed ignition attempts in one cycle and locked the furnace out to protect it. The usual culprit is a weak flame sensor, a dirty burner, or a smart valve that isn’t opening reliably, and the fix depends on which one tests bad. Call (888) 268-6106 and we’ll diagnose it and put the price in writing before any work starts.
Coil leaks on a Lennox unit under about 12 to 15 years old are usually worth repairing with an OEM coil. Past that age, a failed coil often tips toward replacement, especially if the compressor is already working hard. We lean OEM on coils, because an aftermarket mismatch causes callback problems. Call for a written quote on both paths.
Desert heat. A Spring Valley condenser runs almost continuously from June through September with little shade, and run and dual capacitors take that load. Wind-driven monsoon grit loading the condenser speeds up the wear. A failed capacitor can take the compressor’s start winding with it, so it’s worth catching early.
Usually not. On a Dave Lennox Signature system, that message often points to a wiring fault or a board problem rather than a bad thermostat. The mechanical components can be perfectly fine. We trace the communicating path first before recommending a replacement part. Call to get it diagnosed.
No. We lean OEM on control boards, iComfort components, and coils, where a mismatch causes real problems, but we use quality aftermarket for capacitors, ignitors, and common wear parts. If your furnace is still under Lennox warranty, we document the work so the coverage isn’t put at risk.
It depends on the job and the part involved. Here are the ranges we work from:
| Service | Typical price range |
|---|---|
| AC repair | $150 – $650 |
| Furnace repair | $150 – $700 |
| AC installation | $3500 – $7500 |
| Furnace tune-up | $80 – $200 |
Call (888) 268-6106 for an exact quote on your Lennox system. Estimates are free, and the price is in writing before any work begins.
Book Your Lennox Service in Spring Valley, NV
Call (888) 268-6106 to book Lennox AC repair, furnace repair, or a furnace tune-up in Spring Valley. You’ll reach a live person, you’ll get a written price before work starts, and every repair is backed by a written guarantee for a full year. Free estimates, upfront pricing, and no overtime charge.
Written by the team at Dalton Heating & Air.